Blue Clean 1435 - User Manual

Questions and Answers

R
Ronald MarshAug 9, 2025
Why does my Blue Clean Pressure Washer pump not reach working pressure?
- T
  Tina CombsAug 9, 2025
  The pump may not reach working pressure for several reasons: * The nozzle could be worn, requiring replacement. * The water filter might be fouled, needing cleaning. * The water supply may be insufficient; ensure the tap is fully open. * Air could be entering the system; check the tightness of hose fittings. * There might be air in the pump; switch off the appliance and repeatedly depress and release the gun trigger until the water flows steadily, then switch the appliance back on. * The adjustable nozzle may not be positioned correctly; set the nozzle on the (+) setting. * The thermostatic valve may have tripped; wait for the correct water temperature to be restored. * If water is being drawn from an open container, reduce the suction height.
A
amelendezAug 14, 2025
What to do if my Blue Clean Pressure Washer pump pressure drops suddenly during use?
- T
  Thomas HillAug 14, 2025
  A sudden drop in pump pressure during use may occur if: * The appliance is connected to an external tank; connect it to the mains water supply instead. * The inlet water is too hot; reduce the temperature. * The nozzle is clogged; clean it. * The inlet filter is fouled; clean the filter.
J
Julia HaysAug 19, 2025
Why is my Blue Clean Pressure Washer not sucking in detergent?
- P
  Paul HunterSep 12, 2025
  If your pressure washer isn't sucking in detergent, it could be due to several reasons: * The adjustable nozzle is on a high-pressure setting; set it to the " " setting. * The detergent is too dense; dilute it with water. * A high-pressure hose extension is being used; fit the original hose. * There are deposits or restrictions in the detergent circuit; flush with clean water and eliminate any restrictions. If the problem persists, contact an Authorised Service Centre.
D
David LewisAug 25, 2025
What to do if my Blue Clean 1435 has water leakages?
- C
  Christopher BeckerAug 25, 2025
  If you notice water leakages, it could be due to worn seals, in which case you should have them replaced at an Authorised Service Centre. It may also be due to the safety valve tripping and discharging, in which case you should contact an Authorised Service Centre.
J
Jacob FloresAug 29, 2025
Why is my Blue Clean 1435 Pressure Washer appliance noisy?
- R
  Richard MartinAug 29, 2025
  If the appliance is noisy, it could be because the water is too hot. Reduce the temperature, referring to the technical data for guidance.
H
Hunter RodriguezSep 3, 2025
What to do if my Blue Clean Pressure Washer has oil leakages?
- D
  Daniel PorterSep 3, 2025
  If there are oil leakages, it is likely due to worn seals. Contact your nearest Authorised Service Centre to address this issue.