Blue Clean BC383HSS - User Manual

Questions and Answers

A
anthonydavisJul 30, 2025
Why does my Blue Clean BC383HSS turn on for 2 seconds then shut off?
- S
  Sara TurnerJul 30, 2025
  It sounds like your Blue Clean Pressure Washer is working correctly. When the water is connected, the accessories are assembled properly, and the power switch is turned on, the pressure washer may turn on briefly (1-2 seconds) to prime the pump. It automatically shuts off and waits for the spray gun trigger to be pressed. When the trigger is pressed, water starts flowing through the pump. The water sensor in the pump 'senses' the moving water and automatically turns the pressure washer on. Alternatively, turn the power switch off, hold the trigger on the spray gun to ensure a steady stream of water, and while holding the trigger, turn the power switch on.
E
Elizabeth TaylorAug 6, 2025
What to do if the Blue Clean Pressure Washer unit is running but there is no water flow?
- S
  Sherri BairdAug 7, 2025
  If your Blue Clean Pressure Washer is running but no water is flowing, remember that power should NOT be turned on until water comes through the spray gun, as doing so will damage the motor. First, check the water source. Then, eject the nozzle from the lance to see if the clog is coming from the nozzle. If the nozzle is clogged, see nozzle cleaning instructions. Finally, remove the lance and spray directly from the spray gun to determine if the issue lies with the lance itself.
C
conleysarahAug 14, 2025
Why is water leaking from the high pressure hose connection on my Blue Clean Pressure Washer spray gun?
- N
  Nancy OlsonAug 14, 2025
  If water is leaking where the high pressure hose connects to the spray gun of your Blue Clean Pressure Washer, ensure there is an o-ring at the end of the metal tip of the high pressure hose. If the o-ring is missing, the connection will leak. An O-Ring Replacement Kit is included with your purchase. Additional kits are available online or by contacting Customer Service.
P
Pamela BensonAug 20, 2025
How to turn on a Blue Clean Pressure Washer?
- E
  Emily DiazAug 20, 2025
  To turn on your Blue Clean Pressure Washer: 1. Plug the GFCI module on the end of the power cord directly into an outlet. 2. Do not use an extension cord. 3. Ensure the power switch is turned on with the GFCI connected. Note: When the power switch is turned on, the power washer will turn on by itself for 1-2 seconds and shut off. This is normal.