Blue Clean BC2N1HSS User Manual (English)

Questions and Answers:

M
Monique StewartJul 30, 2025
How to troubleshoot Blue Clean BC2N1HSS that will not turn on?
- D
  David CampbellJul 30, 2025
  If your Blue Clean Pressure Washer unit will not turn on, make sure the power washer is OFF, then plug in the electrical cord to a grounded 120 volt outlet (no electrical extension cord should be used). If the electrical cord will not plug into your outlet, your electrical outlet is not properly grounded and should not be used; use another electrical outlet. If it is still not working, try plugging into another electrical outlet and repeat the above procedure. If it is still not working, call Customer Service.
S
Susan StewartAug 4, 2025
What to do if Blue Clean BC2N1HSS Pressure Washer is running but there is no water flow?
- P
  pachecomarkAug 4, 2025
  If the unit is running but there is no water flow in your Blue Clean Pressure Washer, remember that power should NOT be turned on until water comes through the spray gun, as doing so will damage the motor. Check the water source. Eject the nozzle from the lance to determine if clog is coming from the nozzle (If nozzle is clogged, see nozzle cleaning instructions under “Cleaning nozzles”). Take off the lance and just spray out of the spray gun to see if the problem is with the lance. Check Garden Hose Adapter for loose connection and the filter for debris.
D
Donna GallagherAug 10, 2025
Why does my Blue Clean Pressure Washer turn on for 2 seconds, then shut off?
- A
  Andrea FordAug 10, 2025
  When the water is connected, the accessories are assembled properly, and the power is turned on, the Blue Clean Pressure Washer may turn on for 1 - 2 seconds to prime the pump. It automatically shuts off and waits for the spray gun trigger to be pressed. When the trigger is pressed, water starts flowing through the pump. The water sensor in the pump “senses” the moving water and automatically turns the power washer on. You can also try this: turn the power off, hold in the trigger on the spray gun so that you have a steady stream of water. While you are holding the trigger open on the spray gun, at the same time, turn the power on.
K
katiemunozAug 16, 2025
Why is water leaking where the high pressure hose connects to the spray gun of Blue Clean Pressure Washer?
- J
  John MillerAug 16, 2025
  If water is leaking where the high pressure hose connects to the spray gun of your Blue Clean Pressure Washer, make sure there is an o-ring at the end of the metal tip of the high pressure hose. An O-Ring Replacement Kit is included with purchase. Additional O-Ring Kits are available online or you can call Customer Service to place an order.
R
Rebekah DuarteAug 22, 2025
What to do if I can’t remove the lance from the spray gun of Blue Clean Pressure Washer?
- R
  rodriguezmaxwellAug 22, 2025
  All lances are attached and removed from the spray gun of your Blue Clean Pressure Washer in the same manner. Insert the end of the lance into the spray gun. Press the spray gun and lance together (about a 1/8 in.) and turn the collar of the gun clockwise to lock the lance in place. To remove the lance, reverse this procedure: press the spray gun and lance together and turn counter clockwise, then the lance will slide out. You can also hold the spray gun and lance in an upright position with the nozzle end on the floor and push the whole assembly straight down to loosen the connection, and then follow the removal process again. Also, spraying soapy water or a lubricant in the area where the lance connects to the spray gun can help.