Blue Clean 1460 - User Manual

Questions and Answers

N
navarrodestinyAug 13, 2025
What to do if Blue Clean 1460 Pressure Washer pressure drops during use?
- C
  Casey MillerAug 13, 2025
  If the pump pressure drops suddenly during use with your Blue Clean Pressure Washer, the issue might be related to the water source or a clog. If you are using an external tank, try connecting the appliance to the mains water supply. Overheated inlet water could also be the reason, so reduce the temperature. Check the nozzle and inlet filter (L) for clogs and clean them if necessary.
A
Aaron RileyAug 16, 2025
What to do if my Blue Clean 1460 Pressure Washer has oil leakages?
- T
  Tina ByrdAug 16, 2025
  If your Blue Clean Pressure Washer is leaking oil, the seals are likely worn and you should contact your nearest Authorised Service Centre.
S
salasmariaAug 21, 2025
Why is my Blue Clean 1460 so noisy?
- O
  owensjulieAug 21, 2025
  If your Blue Clean Pressure Washer is making excessive noise, it could be due to the water being too hot. You should reduce the water temperature, consulting the technical data for the correct range.
C
Cynthia MillerAug 26, 2025
Why is my Blue Clean 1460 leaking water?
- A
  Alexandra GreenAug 26, 2025
  If your Blue Clean Pressure Washer is leaking water, it may be caused by worn seals. In this case, have the seals replaced at your nearest Authorised Service Centre. The safety valve may also be tripped and discharging, in which case you should contact an Authorised Service Centre.
M
Michelle PetersonAug 30, 2025
Why is my Blue Clean 1460 Pressure Washer not sucking in detergent?
- A
  Andrew WilsonAug 30, 2025
  If your Blue Clean Pressure Washer isn't sucking in detergent, ensure the adjustable nozzle is set to the " " setting. If the detergent is too dense, dilute it with water. Using a high-pressure hose extension can also cause this issue, so fit the original hose. Finally, check for deposits or restrictions in the detergent circuit; flush with clean water and eliminate any restrictions. If the problem persists, contact an Authorised Service Centre.
J
Jill DillonSep 3, 2025
What to do if water escapes from the thermostat valve on my Blue Clean 1460 Pressure Washer?
- A
  Anna WrightSep 3, 2025
  If water escapes from the thermostat valve of your Blue Clean Pressure Washer, it means the water temperature inside the pump head has exceeded the maximum rated value. To resolve this, when the appliance is in operation, avoid stopping the water jet for more than 5 minutes at a time.
C
Christine WhiteNov 7, 2025
Why doesn't my Blue Clean 1460 reach working pressure?
- A
  Ashley MarshallNov 7, 2025
  There are several potential reasons why your Blue Clean Pressure Washer isn't reaching working pressure. It could be due to a worn nozzle, which would require replacement. Alternatively, the water filter might be clogged, necessitating cleaning. Ensure the water supply is fully turned on and check for any air being sucked into the system by verifying the tightness of hose fittings. If there's air in the pump, switch off the appliance and repeatedly depress and release the gun trigger until a steady water flow is achieved, then switch the appliance back on. Also, make sure the adjustable nozzle is correctly positioned to the (+) setting. If the thermostatic valve tripped, wait for the water temperature to restore. Finally, reduce the suction height if water is drawn from an open container f...