Copyright, all rights reserved 11 Version 1 : 011107
Bluelab cleaning kits
The probe surface is where the instrument takes the reading of the solution.
The information is sent back from the probe to the electronic brain of the
instrument. A calculation is then done in the instruments brain or micro
computer and a reading is then displayed. If the information sent back from
the probe is inaccurate due to probe surface contamination then the reading
will be inaccurate.
Cleaning the probes is a very easy task and prolongs the life of
the probes.
Probe cleaning is one of the most important parts of owning
and operating any Bluelab Truncheon
, meter, monitor or
controller. If the probe is contaminated (dirty), it affects the
accuracy of the reading displayed.
The Bluelab cleaning kits have it all there for you:
conductivity probe cleaning kit
full colour instructions
conductivity standard solution
decanter vessel
Bluelab probe cleaner
Bluelab chamois (probe cleaning instrument)
pH cleaning and calibration kit:
full colour instructions
calibration solutions
decanter vessels
Bluelab probe cleaner
Bluelab pH probe cleaning tool
toothbrush
The instrument is only as accurate as the probe is clean!
To Previous Page
Loading...
Need help?
General
