AVENTOS HK top Assembly
AVENTOS
Attaching AVENTOS HK top doors
Adjust the lift mechanism
Use a T20 TORX screwdriver or screw gun and a T20 TORX bit to adjust the lift mechanism to the desired tension (door weight balanced).
Cover cap does not need to be removed to perform this adjustment.
Warning: Risk of injury by spring-loaded lever arm!
▬ Arm has built in safety feature to prevent opening and closing
▬ Secure lever arm before installing cabinet
Remove positioning template
Push the positioning template down to remove.
Press up on arm release slide then slowly raise the arm to the upright position.
Attach the door using the CLIP mechanism to the arm assembly.
1 2
1
2
1
2
1
2
© 2021 Blum, Inc. Subject to technical modifications without notice
16
To Next Page
Loading...
