RS232 and Telnet Commands
The Blustream HMXL88 V2 can be controlled via serial and TCP/IP. The following pages list all available serial commands for the
HMXL88 V2 Matrix. Details of RS232 pin assignment can be found on page 05.
Commonly used Serial commands:
There are several commands that are commonly used for control and testing:-
STATUS Status will give feedback on Matrix such as zones on, type of connection etc
PON Power on
POFF Power o
OUTxxON (xx is the zone number you wish to turn on)
Example:- OUT01ON (This would turn output one back on)
OUTxxFRyy (xx is the zone out, yy is the input)
Example:- OUT01FR04 (This would switch output 1 to source input 4)
Common Mistakes
• Carriage return – Some programs do not require the carriage return where as other will not work unless sent directly aer the
string. In the case of some Terminal soware the token <CR> is used to execute a carriage return. Depending on the program you
are using this token maybe dierent. Some other examples that other control systems deploy include \r or 0D (in hex)
• Spaces – Blustream commands do not require space between commands unless specified. There may be some programs that
require spacing in order to work.
- How the string should look is as follows OUT01ON
- How the string may look if spaces are required: OUT{Space}01{Space}ON
• Baud rate or other serial protocol settings not correct - Please see Page 5 for Matrix settings
RS232 Command Description
? Print Help Information
HELP Print Help Information
STATUS Print System Status And Port Status
PON Power On, System Run On Normal State
POFF Power Off, System Run On Power Save State
IRON/OFF Set System IR Control On Or Off
KEYON/OFF Set System KEY Control On Or Off
DBG ON/OFF Set Debug Mode On Or Off
BEEPON/OFF Set Onboard Beep On Or Off
RESET Reset System To Default Setting (Should Type “Yes” To Confirm, “No” To Discard)
OUTxxON/OFF
Set OUTPUT:xx On Or Off
OUTxxFRyy Set OUTPUT:xx From INPUT:yy
EDID xxCPyy
To Next Page
Loading...
Need help?
General
