Remote Control Description
OUTPUT AND INPUT SELECTION
A Selects the zone OUTPUT you wish to
change the source on (Numbers 1 - 4
correspond to the zone outputs 1 - 4)
B Selects the source INPUT you wish
to change on the selected zone
(Numbers 1 - 4 correspond to the
source inputs 1 - 4)
EXAMPLE
To switch source 2 to zone 4 you
would press 4 in the output section
(A) followed by pressing 2 in the Input
section (B).
ALL button: The all button selects
all the inputs or outputs in its
corresponding box. Example: (The “All”
button in the Output box selects all the
zones so all zones will change to what
source input is selected next)
PTP: This button will align all the zone
outputs with the like numbered source
inputs. Example: Input 1 to output 1,
input 2 to output 2, etc
EDID SET UP
The MX44AB-V2 provides a
comprehensive range of EDID settings.
Below are three examples of how to
deploy the desired EDID setting when
using the supplied remote.
A. Fix EDID to an Input or ALL inputs:
Press the desired video resolution
button (1080I / 1080P / 3D / 4K),
then select the desired audio format
(2.0CH / 5.1CH / 7.1CH), then select
the source input you want this EDID
information allocated to by pressing
the INPUT 1 – 4 or the ALL button
B. Copy EDID of Output-X to an Input
or ALL: Press the COPY but-ton then
select the OUTPUT you wish to copy
the EDID information from, then
select the source input you want to
copy this EDID to by selecting the
INPUT 1-4 or the ALL button.
C. User defined EDID to an Input or
ALL inputs: Press USER1 / USER2
button then select the source you
wish to assign this EDID to by select-
ing INPUT 1-4 or the ALL button
POWER
OUTPUT
INPUT
1 2 3 4
1 2 3 4
1080I
2.0CH
USER 1 USER 2 FN1 FN2
EDID
5.1CH 7.1CH COPY
1080P 3D 4K
ALL
PTPALL
EDID
B
A
NOTE: THE BUTTON PRESS SEQUENCE SHOULD BE FINISHED IN 5 SECONDS,
OTHERWISE THE OPERATION IS DISCARDED
To Next Page
Loading...
