Possible cause:
The high-voltage service discon-
nect has been disconnected and
the high-voltage system is deac-
tivated.
Note the following:
NOTICE
Only an authorised
BMW Motorrad dealer is
permitted to disconnect the high-
voltage safety connector.
RBS/TCA fault
appears on the display.
Possible cause:
The motor control unit has de-
tected a fault. Energy recovery
by deceleration of the vehicle is
only conditionally available.
Have fault rectified as soon
as possible by an authorised
BMW Motorrad dealer.
TCA self-diagnosis not
completed
flashes.
Possible cause:
Self-diagnosis did not complete,
so the TCA function is not avail-
able. The E-Scooter must be rid-
den at a speed of at least 5 km/h
for TCA self-diagnosis to com-
plete.
Pull away slowly. Bear in mind
that the TCA function is not
available until self-diagnosis has
completed.
TCA fault
lights up yellow.
appears on the display.
Possible cause:
The TCA is not available. The
rear wheel might spin under ac-
celeration and energy recovery
by deceleration of the vehicle is
not available.
Have fault rectified as soon
as possible by an authorised
BMW Motorrad dealer.
ABS self-diagnosis not
completed
flashes.
Possible cause:
Self-diagnosis did not complete,
so the ABS function is not avail-
able. The E-Scooter must be rid-
den at a speed of at least 5 km/h
in order for ABS self-diagnosis to
complete.
Pull away slowly. Bear in mind
that the ABS function is not
available until self-diagnosis has
completed.
3
32
z
Status indicators
To Next Page
Loading...
