The charging procedure is
not started until the operating
readiness is switched off. The
charging procedure will be in-
terrupted if operating readiness
is switched back on during the
charging procedure.
Open the flap on the left.
Remove the charging socket
cap 1.
Plug in the standard charging
cable from the domestic socket
or the Mode3 charging cable
from the charging station. Fol-
low the instructions on the
charging station if you are char-
ging at a charging station.
The standard charging cable
automatically runs all the test
steps required. The test was
successful if LED 1 lights up
green. If the LED 3 lights up
red, the test was failed and
the charging procedure can-
not start or the charging cable
must not be connected to the
vehicle. The following test
steps are run:
Testing the wall socket for in-
correct wiring
Testing for the presence of a
protective earth
Testing the requirements for
correct charging
The status displays and fault
messages are listed in the
"Technical Data" section. Any
fault messages displayed can
be reset as follows:
Disconnect the standard char-
ging cable from the voltage
supply by unplugging the plug
from the wall socket.
Plug the plug back in after 3
seconds.
Critical faults which indicate
damage to the standard char-
ging cable are not reset. These
faults include:
Relay welded up (equipment
permanently damaged)
Faulty temperature sensor
6
70
z
BMW ePOWER
To Next Page
Loading...
