The bar display 1 for the state
of charge appears. The state
of charge is also indicated as a
numerical percentage value 2.
After a certain time the TFT
display is automatically switched
to Stand-by-Modus (power eco-
nomy mode).
Press the INFO or TRIP
button briefly to display the
current state of charge again.
Ending the charging
procedure
Requirement
The following steps must be
taken in this order to end the
charging procedure.
Requirement
Unlock the connector before un-
plugging it. End the charging
procedure at the charging sta-
tion before unplugging the char-
ging cable if you are charging at
a charging station.
Remove the padlock 2 from
the charging cable 1 if neces-
sary.
Press release button 3 and un-
plug the charging cable 2 from
6
72
z
BMW ePOWER
To Next Page
Loading...
