2
30
Maintenance and care
Notes on changing bulbs
Your vehicle is equipped with a
digital electronic engine man-
agement system (BMS) and a
high-output ignition system.
d
Warning:
Work on the electrical system
only when the circuit has
been interrupted (switch off
ignition and lights). For
greater safety, disconnect
and insulate the negative bat-
tery lead.
When the engine is running or
the ignition is switched on, do
not touch electrically live
components, terminals or
wiring.
– Risk of fatal accident.
e
Important:
Your vehicle has a high-beam/
low-beam bulb, a parking-light
bulb, a brake-light bulb and a
rear-light bulb.
If any of these bulbs fail, you
may have problems in seeing
and being seen.
You should therefore always
carry spare bulbs on the
vehicle.
L
Note:
Do not touch new bulbs with
the fingers.
Use a clean, dry cloth to hold
the bulbs when inserting them.
Dirt deposits, in particular oil
and grease, interfere with heat
radiation from the bulb. This
leads to overheating and short-
ens the bulb's operating life.
To Next Page
Loading...
