BMW E65 - Page 24

24© BMW AG, München 01 29 0 406 372 12.2005 (Z/Z)
8. To install the monitor
Secure the adhesive marking (1) that you pre-
viously fitted on the seat wiring harness F to the
seat backrest (2) as shown using a cable tie AP.
Thread branches F1 and F2 through the front
seat rear panel (1).
Install the front seat rear panel (1) as described in
TISRA5215198.
Unscrew the tooth washer (1) and hexagonal nut (2)
from the auxiliary cable
G and headphone cable H .
Insert the auxiliary cable G into the front monitor
trim AT on the left and secure it with a toothed
washer (1) and hexagonal nut (2).
Insert the headphone cable H into the front
monitor trim AT on the right and secure it with a
toothed washer (1) and hexagonal nut (2).
Insert grommets AL into the monitor AA.
Thread headphone connector AA1 for the
monitor AA through the top grommet AL.
Insert cable ties AP into the existing holes.
1
2
1
F
AP
AP
060 0667 Z
1
F2
F1
060 0762 Z
21G
H
AT
060 0670 Z
AL
AP
AA1
AP
AA
060 0661 Z