2
34
Maintenance and care
Notes on changing bulbs
e Attention:
Your motorcycle has one bulb
for the low-beam headlight and
one for the high-beam head-
light, one for the parking light,
one for the brake light and one
for the rear light and one for the
number-plate light, plus four
bulbs for the turn indicators.
If any of these bulbs should fail,
you may have problems in see-
ing and being seen.
You should therefore always
carry spare bulbs on the motor-
cycle.
L Note:
Do not touch new bulbs with
your fingers.
Use a clean, dry cloth to hold
the bulbs when inserting them.
Dirt deposits, in particular oil
and grease, interfere with heat
radiation from the bulb. This
leads to overheating and short-
ens the bulb’s operating life.
20K14bkg3.book Seite 34 Mittwoch, 19. Mai 2004 11:57 11
To Next Page
Loading...
