2
38
Maintenance and care
Changing bulbs
Number-plate light
e Attention:
Switch off the ignition before
changing a bulb.
L Note:
Do not touch new bulbs with
your fingers.
Use a clean, dry cloth to hold
the bulbs when inserting them.
• Prop the motorcycle on its
side stand
• Remove two retaining
screws 4
• Carefully remove number-
plate light 1 from below
•Remove cap 2.
• Press bulb 3 into its socket,
and disengage it by turning it
counter-clockwise
• Remove the bulb
• Installation is the reverse of
the removal procedure
– Number-plate light bulb 3:
12 V 6 W
L Note:
When installing the bulb, make
sure the pins on the base are
correctly aligned with the re-
cesses in the socket.
Make sure that cap 2 is correct-
ly seated.
1
2
3
4
20K14bkg3.book Seite 38 Mittwoch, 19. Mai 2004 11:57 11
To Next Page
Loading...
