2
37
Maintenance and care
Rear/brake light
e Attention:
Switch off the ignition before
changing a bulb.
L Note:
Do not touch new bulbs with
your fingers.
Use a clean, dry cloth to hold
the bulbs when inserting them.
• Prop the motorcycle on its
side stand
– Make sure the ground is
level and firm.
• Remove two screws 3
• Pull rear light glass 2
to the rear and remove
•Press bulb1 in the forward
direction of travel and turn it
counter-clockwise to disen-
gage it from its socket
• Remove the bulb
• Installation is the reverse of
the removal procedure
– Brake/rear light bulb:
12 V 21/5 W
Changing bulbs
1
2
3
20K14bkg3.book Seite 37 Mittwoch, 19. Mai 2004 11:57 11
To Next Page
Loading...
