2
36
Maintenance and care
Changing bulbs
Flashing turn indicators
e Attention:
Switch off the ignition before
changing a bulb.
L Note:
Do not touch new bulbs with
your fingers.
Use a clean, dry cloth to hold
the bulbs when inserting them.
• Prop the motorcycle on its
side stand
– Make sure the ground is
level and firm.
• Remove securing screw 1
• Remove flashing turn indica-
tor glass 3
• Press bulb 2 into the socket,
turn it counter-clockwise to
disengage it and remove
• Installation is the reverse of
the removal procedure
– Flashing turn indicator bulbs 2
front/rear: 12 V 10 W
3
2
1
20K14bkg3.book Seite 36 Mittwoch, 19. Mai 2004 11:57 11
To Next Page
Loading...
