24 DISPLAYS
Color of the icon
Green: (OK) current value is optimal.
Blue: (Cold!) current temperature is low.
Yellow: (Low!/High!) current value is too
low or too high.
Red: (Hot!/High!) current temperature
or value is too high.
White: (---) There is no valid value. Instead
of the value, dashes are displayed.
The evaluation of the individual val-
ues is possible in part only after a cer-
tain riding duration or speed. If a measured
value cannot yet be displayed due to unful-
filled measurement conditions, dashes are
displayed instead as placeholders. As long
as no valid measured value is available, no
evaluation is carried out in the form of a col-
ored symbol.
Check Control dialog
Messages are output as Check Control dia-
log 1.
If several Check Control messages of the
same priority are present, the messages
change in the order in which they occur,
until they are acknowledged.
If the icon 2 is active, this can be acknowl-
edged by tilting the Multi-Controller to the
left.
Check Control messages are dynamically
attached as additional tabs to the pages
in the menu My vehicle ( 70). You
can go back to the message as long as the
error persists.
To Next Page
Loading...
