6.3 General safety instructions
Apart from the notes in these operating instructions the general safety and accident prevention
regulations must be observed:
• The material-installation lift may only be operated if all protection systems are fully
functional and there is no apparent damage to the lift. Prior to each commissioning, the
material-installation lift must be checked for external visible damage and functionality of
existing safety devices
• The operator is responsible to ensure that all persons using the material-installation lift
have read and understood the entire operating instructions, paying particular attention to
the chapter “Safety”!
• Böcker Maschinenwerke GmbH does not accept any liability for damage resulting from
failure to comply with the operating instructions!
• Unauthorised modifications and alterations of the material-installation lift relating to
safety are expressly prohibited!
• This include for example:
1. - Removal of safety devices
2. - Installation of non-original components etc...
Böcker Maschinenwerke GmbH does not accept any liability for damage attributable to such
actions! These are carried out solely at the risk of the user! Operating and maintenance tasks
must only be carried out by qualified personnel who are familiar with these operating and
maintenance instructions.
The operational safety of the material-installation lift is only ensured if the lift is used as
intended. In case of doubt, the manufacturer should be consulted. The manufacturer does not
accept any liability for damage caused as a result of improper use of the unit!
During all works, the existing respective domestic regulations regarding accident prevention
and occupational safety, as well as, if applicable, the internal regulations of the respective
operator, must be complied with, even if these are not comprehensively described in these
instructions.
The respective local applicable legal safety regulations must be complied with.
When any work is carried out on the unit, the surrounding area must be free from obstructions.
The work area should, if possible, be identified or marked in colour and if necessary, cordoned
off.
Always ensure that you are wearing protective clothing (protective helmet, glasses,
gloves) when using the material lift!
To Next Page
Loading...
