3 Installation
3.1 Notes
The material-installation lift has undergone a function test prior to professional packing! The
packaging material must be disposed of or reused in accordance with the applicable rules of
each country of installation.
During the installation of the equipment/system, the following safety instructions must always
be observed, in order to avoid life-threatening injuries, damage to machinery/systems and
other material damage.
• Upon delivery, check the material lift for damage. Only a faultless material lift may be set
up. Any potential transport damage must be immediately reported by the transport
company or the responsible body. If appropriate, the lift must not be commissioned.
• Setting up, assembly and installation of the material lifts may only be carried out by
qualified persons in compliance with the safety instructions.
• The transport locks may only be removed when the components have been taken to their
ultimate position and when they have been properly mounted there.
• Prior to the start of the setting-up work, all components must be checked for transport
damage. Pay particular attention to the cable guide (Danger: slack cable!)
• It must be ensured that only authorised persons are present in the work area and that
other persons are not exposed to hazards by the setting-up work.
• The material lift may only be set up on level and suitable (bearing capacity, oil tightness)
areas.
• All connections in the material lift - e.g. cables or similar - must be laid in such a way that
they do not cause any risk of stumbling.
• The rules for the operating materials, lubricants and auxiliary supplies must be observed.
• Welding operations cause a fire hazard, therefore it is imperative to be familiar with the
fire-extinguishing appliances on site.
3.2 Setting-up of the material-installation lift
First install the chassis with both front parts, by loosening and removing the horizontally
integrated hexagon screw M16 x 170 with the hexagon nut.
Fold down the front parts in order:
First, fold down one front part, push the hexagon screw M16 x 170 into the existing hole from
above and firmly screw in with the hexagon nut. Repeat this process for the remaining side.
To Next Page
Loading...
