Bomag BPR 35/60 D - 6-Monthly Maintenance: Engine Oil Filter

Maintenance every 6 months
BOMAG 44 BPR 35/40 D BPR 35/60 D
Fig. 46
l Fill in new engine oil (Fig. 46).
For quality and quantity of oil refer to the table
of fuels and lubricants.
l Push the dipstick in again.
l Perform a test run, inspect drain plug and oil
filter for leaks.
5.13 Clean the engine oil filter
!
Caution
Remove and clean the engine oil filter only af-
ter draining off the engine oil.
Fig. 47
l Loosen the fastening screw and pull the en-
gine oil filter out of the housing (Fig. 47).
l Blow the engine oil filter out with compressed
air from inside to outside.
l Cover the seal slightly with oil.
l Push the engine oil filter into the housing and
tighten the fastening screw.
l After filling in engine oil perform a short test
run and check for leaks, if necessary tighten
the fastening screw.
Go to Discount-Equipment.com to order your parts