Bomag BPR 35/60 D - Page 53

Maintenance every year
BOMAG 53 BPR 35/40 D BPR 35/60 D
Fig. 67
l Check whether the hydraulic oil level is ap-
prox. 40 mm below the filler opening (Fig. 67),
topupifnecessary.
For quality of oil refer to the table of fuels and
lubricants.
Filling up hydraulic oil
Fig. 68
i
Note
Lay a cloth down before slackening the venting
screw.
l Shift the travel lever forward against the stop.
Fig. 69
l Slacken the bleeding screw.
l Wait until all air has escaped (Fig. 69).
l Tighten the bleeding screw.
Fig. 70
l Fill in hydraulic oil to approx. 40 mm below the
edge of the filler opening (Fig. 70).
i
Note
After bleeding check the hydraulic oil level, top up
if necessary.
Go to Discount-Equipment.com to order your parts