BorMann BBS2100 - Curved Cuts; Ending the Operation; Cleaning, Maintenance and Storage

10
WWW.NIKOLAOUTOOLS.GR WWW.NIKOLAOUTOOLS.GR
EN EN
Angular cuts
Notes
There are two opons for sawing diagonally:
• Sawing with a lted saw table (Fig. B)
• Sawing with a mitre gauge fence (Fig. C)
For cung dovetail-shaped nes and tenons or wedges, move the saw table to the corresponding posion on the angle scale.
Aer each new adjustment, we recommend a trial cut in order to check the set dimensions.
Sawing with a lted saw table (Fig. B)
1. Set the saw table to the desired inclinaon (see secon Tilng the saw table).
2. If possible, aach the rip fence to the right side of the saw table. This will prevent the workpiece from slipping.
Sawing with a mitre gauge fence (Fig. C)
1. Set the cross stop (20) to the desired angle.
2. Slide the rail of the cross stop into the guide on the saw table (7).
3. With the machine switched o, check that the guide is completely inside the rail at the start of the cut. If not, you should saw the cut dierently, for example
with a lted saw table.
4. If possible, aach the rip fence to the le side of the saw table.
Curved cuts
CAUTION! Your ngers are parcularly at risk when cung curves! Take special care.
1. Remove the rip fence and the mitre gauge fence.
2. Use an auxiliary template for execung repeat curved, irregular cuts.
3. When making curved and irregular cuts in the workpiece, push the workpiece evenly forward using both hands, with your ngers closed. Keep your hands
in the safe area when holding the workpiece.
Ending the operaon
1. Press the OFF buon O (32).
2. Pull out the mains plug.
3. Release the tension of the band saw blade, see Checking and adjusng the tension of the band saw blade, p. 28. The life of the band saw blade is reduced
if stored with tension.
4. Clean the machine.
CLEANING, MAINTENANCE AND STORAGE
WARNING! Electric shock! Remove the mains plug before carrying out any adjustments, maintenance or repair work.
CAUTION! Risk of burn injury! Allow the machine to cool o before any maintenance or cleaning is undertaken.
NOTE: Have any work that is not described in this instrucon manual performed by an authorised service centre. Only use original replacement parts.
Cleaning
WARNING! Electric shock! Never spray down the machine with water.
NOTE: Risk of damage. Chemical substances may aack the plasc parts of the machine. Do not use any cleaning agents or solvents.
Cleaning the outside of the machine
WARNING! Cung injuries! Wear cut-resistant gloves when working with the saw blade.
1. Keep the venlaon slits, motor housing and handles of the machine clean. Use a damp cloth or brush to do this.
2. Clean resinous surfaces with a damp, lukewarm cloth that has been wrung out well. Make sure that no liquids can get into the interior of the housing!