Borri B500-R100-C User Manual

35
Fig. 5.8
Converter mode
In converter mode, the UPS will free run with
fixed output frequency (50Hz or 60Hz). Once
the mains is lost or abnormal, the UPS will
transfer to battery mode and the load is
supplied continuously.
1) The function could be enabled through
the LCD setting or the software
(Winpower, etc.).
2) The load should be derated to 80% in
converter mode.
Fig. 5.9
Warning:
When the warning occurs, it indicates
abnormal problems during the operation of
the UPS. Normally the problems are not fatal
and the UPS continues working, but they
should be addressed, or the UPS may fail.
Fig. 5.10
Fault:
When a fault occurs, it indicated a serious
problem has happened, the UPS will cut off
the output or transfer to bypass, and keep
alarming. The backlight of LCD will also turn
to red.
Fig. 5.11
Overload:
When the UPS is overload, the alarm will
beep twice every second. Some unnecessary
loads should be removed one by one to
decrease the loads connected to the UPS.
Battery Test
UPS is executing a battery test

Borri B500-R100-C Specifications

General

Brand	Borri
Model	B500-R100-C
Category	UPS
Language	English