20 en | Installation Automatic Detectors LSN improved
2019.11 | 4.0 | F.01U.025.877 Operation Guide Bosch Sicherheitssysteme GmbH
Mode Terminal connection Alarm condition
1
The remote indicator shows steady red light.
2
The remote indicator shows steady red light.
3
The remote indicator shows flashing red light.
Operate in mode 1 and 3 only, when connected to LSN detectors.
1. Place the cap on the base plate in such a way that the two hooks are inserted into the
slits.
2. Press the cap lightly onto the base plate until the snap‑fit‑hook engages.
FAA‑420‑RI‑ROW
1. Wire the remote indicator as shown.
2. Place the cap on the base plate in such a way that the two hooks are inserted into the
slits.
3. Press the cap lightly onto the base plate until the snap‑fit‑hook engages.
To Next Page
Loading...
