Delete error log entries
After carrying out the problem‐solving actions, delete the entry from the error
log by clicking on the “Clear Faults” button, as seen below:
Then turn ABS M4 off and on again. After you deactivated the software, the indi‐
cation lamp will no longer glow.
Notice
If the faults are not all clearly described or if there is no error
description, please check if you used the correct FPS-File or
contact Bosch Motorsport for update.
Ignition Cycle Counter
The ignition cycle counter shows how often you switched on the ignition. If you
compare the values of the ignition cycle counter and ICC at Failure Occurrence
you can trace back at what time the faults occurred. If both fields show the same
values, it is an actual fault.
Programming and Diagnosis Software | 9
Bosch Motorsport ABS M4 Manual 37 / 54
To Next Page
Loading...
