Bosch ACS 810 - Page 2

| 36 | ACS 810 | en
1 689 989 601 2020-12-01| Robert Bosch GmbH
11. ACS 810 settings 58
11.1 Factory setting 58
11.2 Set unit 58
11.3 Set length of service hoses 58
11.4 Contrast 58
11.5 Enter serial number 58
11.6 Flush (optional) 58
11.7 Expert mode 59
11.8 Service data report 59
11.8.1 Activate/deactivate consumption
R134areport 59
11.8.2 Printing data 59
11.8.3 Exporting data 59
11.8.4 Deleting data 59
12. Maintenance 60
12.1 Cleaning 60
12.2 Spare and wearing parts 60
12.3 Maintenance interval 60
12.4 Calibrating internal refrigerant cylinder scales 60
12.5 Removing the fresh and used oil bottles 60
12.5.1 Removing the fresh oil bottle 60
12.5.2 Removing the used oil bottle 60
12.6 Software update 61
12.6.1 Firmware 61
12.6.2 Vehicle database 61
12.7 Replacing printer paper 61
12.8 Periodic check of the non-condensable gas
purge valve 61
12.9 Combo filter 62
12.9.1 Replacement of combo filter 62
12.9.2 Reset filter 62
12.10 Vacuum pump 63
12.10.1 Changing vacuum pump oil 63
12.10.2 Reset of oil change interval 63
13. Decommissioning 64
13.1 Temporary shutdown 64
13.2 Change of location 64
13.3 Disposal and scrapping 64
13.3.1 Substances hazardous to water 64
13.3.2 Disposal of LCD display 64
13.3.3 Disposal of refrigerants, lubricants
andoils 64
13.3.4 Disposal of combo filter 64
13.3.5 ACS 810 and accessories 64
14. Glossary 65
15. Technical data 65
15.1 ACS 810 65
15.2 Ambient temperature 65
15.3 Air humidity 65
15.4 Electromagnetic compatibility 65