Need help?Do you have a question about the Bosch WBE 4200 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | WBE 4200 |
| Category | Service Equipment |
| Language | English |
Explains warning notices, structure, and symbols used within the documentation.
Details product identification plates and warning indications displayed on the machine.
Highlights crucial information on copyright, liability, and user obligations.
Refers to essential safety instructions found in a separate manual for safe operation.
Discusses EMC directives and potential interference caused by the WBE 4200.
Defines the WBE 4200 as a wheel balancing machine for specific rim sizes and purposes.
Outlines installation requirements, emphasizing a flat, anchored surface for accurate measurements.
Provides a detailed overview and illustration of the WBE 4200 machine.
Describes the various elements and indicators on the WBE 4200 control/display panel.
Explains the function and designation of each key on the control panel for operation.
Guides on accessing and configuring the machine's operational settings via the menu.
Details how to access and modify board configuration settings using the menu.
Provides instructions for various calibration procedures required for accurate machine performance.
Details the MSR function for checking pick-up voltage and sensor signals.
Explains how to check the encoder's function and its range of values.
Describes the SP function for monitoring the shaft's rotation speed during balancing.
Covers analog signal readings from sensors and potentiometers for defect identification.
Step-by-step instructions for replacing the pick-up unit on the machine.
Procedures for removing and replacing the Easyfit® calliper unit.
Guide on how to replace the engine belt of the WBE 4200.
Instructions for replacing the main power board of the machine.
Steps for replacing the CPU board and configuring the machine afterwards.
Detailed steps for correctly positioning the distance potentiometer.
Instructions for the proper positioning of the diameter potentiometer.
Guidelines for cleaning and routine servicing of the WBE 4200 machine.
Lists recommended spare parts for maintenance and repair of the WBE 4200.
Lists essential tools required for performing assistance and maintenance tasks.
Outlines the standard calibration sequence for ensuring machine accuracy.
How to access the factory calibration menu.
Instructions for factory flange calibration, referencing standard procedure.
Instructions for factory calibration of the electronic vernier caliper.
Steps for performing factory calibration using a sample weight.
To Next Page
