1 695 600 091 2012-11-16| Robert Bosch GmbH
38 | WBE 4200 | User informationen
3.3 WBE 4200
Fig. 1: WBE 4200
Item Designation Function/purpose
1 Control panel Operation of WBE 4200
2 Vernier caliper (electronic) R Recording of rim distance and rim diameter.
R Determination of positions for attachment of adhesive weights.
3 Wheel guard, moving R Protection of operator against flying particles (e.g. dirt, water).
R Starting and stopping measurement.
4 Pedal Blocking of wheel for attachment or removal of balance weights.
5 Tray For storing balance weights and accessories.
6 On/off switch Switching WBE 4200 on and off
7 Clamping tool holders Storage of accessories
8 Mains socket Connection for power cord.
9 Connection for angular width gauge* Connect the angular width gauge to the machine.
10 Quick-action clamping nut Centering and attachment of wheel on cone
11 Centering flange with tie rod Wheel attachment.
12 Centering cone Centering of wheel on flange shaft.
13 Manual vernier caliper Can be used as substitute if the electronic vernier caliper is defective.
14 Balance weight pliers For attaching balance weights to rim and removing weights.
15 Measuring compasses Can be used as substitute if the rim width and rim diameter cannot be recorded
electronically.
16 Concave sleeve For use with quick-action clamping nut and for external attachment of centering
cone.
17 Spacer ring For use with quick-action clamping nut and aluminum rims..
18 Rubber guard ring For use with quick-action clamping nut and aluminum rims.
19 Plastic spatula For removing adhesive weights
* special accessories
To Next Page
Loading...
