What to do if there is no display on the keypad after power up for Bosch Security System?
If your Bosch Security System keypad isn't displaying anything after powering up, it could be due to a failure in the AC power or battery fuses, or abnormal RBGY wiring. Check that the AC power and battery fuses are properly connected and functioning correctly. Also, try reconnecting the RBGY wiring.
What to do if my Bosch AMAX 2100 keypad is not responding?
If your Bosch Security System keypad is unresponsive and emits a wrong tone when you press any key, it could be due to: * Abnormal RBGY wiring. * The keypad being locked after entering incorrect passwords multiple times. * An incorrect jumper setting when using multiple keypads. To fix this, try reconnecting the RBGY wiring. If the keypad is locked, wait for 3 minutes before trying again. If you are using multiple keypads, reset the jumper referring to the keypad address settings information.
How to fix a constant on zone indicator on a Bosch AMAX 2100?
If a zone indicator on your Bosch Security System is constantly on, it could be due to incorrect zone wiring, a malfunctioning detector, or the zone EOL resistor not being correctly connected to the end of the detector. Try re-entering the zone wiring, resetting the detector, and ensuring the zone EOL resistor is correctly connected to the end of the detector.
General| Series | AMAX |
|---|---|
| No of Keypads | 4 |
| No of Users | 32 |
| Communication Formats | Contact ID, SIA |
| Operating Temperature | -10°C to +55°C |
| Protection Class | IP30 |
| Storage Temperature | -20°C to +55°C |
| Relative Humidity | 93% non-condensing |
| Event Buffer | 256 events |
To Next Page
