P The FAULT indicator is turned off when there is no other system fault.
– RF Config Failure
Configuration Conflict Sensors
Condition:
A wireless zone configuration is in error condition.
Restore:
4 Restore all wireless zones to a normal condition and reset the fault. For more
information, refer to RF Devices, page 83.
Supervise:
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
4 Reset the fault.
P The FAULT indicator is turned off when there is no other system fault.
Configuration Conflict Repeaters
Condition:
A repeater configuration is in error condition.
Restore:
4 Restore all repeaters to a normal condition and reset the fault. For more information,
refer to RF Devices, page 83.
Supervise:
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
4 Reset the fault.
P The FAULT indicator is turned off when there is no other system fault.
Configuration Conflict Keyfobs
Condition:
A keyfob configuration is in error condition.
Restore:
4 Restore all keyfobs to a normal condition and reset the fault. For more information, refer
to RF Devices, page 83.
Supervise:
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
4 Reset the fault.
P The FAULT indicator is turned off when there is no other system fault.
2 - Power Failure
– Panel AC Failure
Condition:
1. AC supply deficiency caused by a transformer.
2. Power supply fuse is broken (230V).
3. Power supply is disconnected (230V).
Restore:
1. Reconnect the AC supply and reset the fault. For more information refer to Installation,
page 26.
2. Monitor the voltage by MPU.
Supervise:
1. If the AC supply is not restored one hour after the fault occurred, report the fault to
configured destination on address 124.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
150
en | Troubleshooting AMAX panel
2015.05 | 06 | F.01U.309.277 Installation Manual Bosch Sicherheitssysteme GmbH
To Next Page
Loading...
