AUTODOME IP 5000i IR Installing a Surveillance Cabinet and Camera | en 15
Bosch Security Systems Installation Manual 2017.08 | 1.0 |
7 Installing a Surveillance Cabinet and Camera
The surveillance cabinet can attach directly to a wall, to a corner mount, or to a pole mount.
To install the cabinet (power supply box), follow the instructions in the Surveillance Cabinet
Installation Manual.
1. Thread the cables through the wall and the mounts.
Ensure that the cables are long enough to reach through the mount and the camera’s
mounting cap to the connections from the camera.
7.1 Installing the Wall Mount
1. Slide the mounting flange over the wall mount.
2. Attach the wall mount to the mounting flange and fix them on the front door of the Wall-
mount Surveillance Cabinet by using four M5 screws.
7.2 Attaching the Mounting Cap and the Camera
1. To ensure a watertight seal, wrap Teflon tape four times around the threads at the end of
the wall mount.
2. Attach the mounting cap to the wall mount.
3. Thread all connection cables through the mounting cap.
4. Attach the hook at the end of the Safety Tether to the loop attached to the top of the
camera.
5. Connect the mating connectors on the user-supplied cables to the matching connectors
on the camera. Refer to the chapter Connection for more information.
To Next Page
Loading...
