Bosch Bulls Cross Lite Evo - Page 107

MY20B01-22_1.0_21.06.2019
106
Documents
Inspection Tests Maintenance Accept-
ance
Rejection
Light system
Rechargeable
battery
First examination O.K. Error message Contact battery
manufacturer; take out of
service, new battery
Light cabling
Connections, correct
wiring
O.K. Cable defective,
no light
New cabling
Rear light
Side light Functional check O.K. No constant light New rear light as specified in
parts list; replace battery if
necessary
Front light
Side light, daytime
riding light
Functional check O.K. No constant light New front light as specified
in parts list; replace battery if
necessary
Reflectors
All complete, state,
fastening
O.K. Damaged or not
all complete
New reflectors
Drive/gear shift
Chain/cassette/
pinion/chainring
Check for damage O.K. Damage Refasten if necessary or
replace as specified in parts
list
Chain guard/
spoke guard
Check for damage O.K. Damage Replace as specified in parts
list
Bottom bracket
axle/crank
Check mount fastening O.K. Loose Retighten screws
Pedals Check mount fastening O.K. Loose Retighten screws
Shifter Check mount fastening Functional check O.K. Loose Retighten screws
Shift cables
Check for damage Functional check O.K. Loose or
defective
Adjust shift cables; new shift
cables if necessary
Front derailleur
Check for damage Functional check O.K. Gear shift difficult
or not possible
Adjust
Rear derailleur
Check for damage Functional check O.K. Gear shift difficult
or not possible
Adjust
Electric drive
Display
Check for damage Functional check O.K. No screen
display, defective
screen display
Restart, test battery, new
software, or new display;
take out of service,
Electric drive con-
trol panel
Check drive for
damage
Functional check O.K. No response Restart; contact control
panel manufacturer, new
control panel
Tachometer
Speed measurement O.K. Pedelec
travelling 10%
too fast/slow
Shut off pedelec until source
of fault is found
Cabling
Visual inspection O.K. Failure in
system, damage,
kinked cables
New cabling
Battery mount
Firmly in position, lock,
contacts
Functional check O.K. Loose; lock
doesn't close, no
contacts
New battery mount
Motor
Visual inspection and
mount
O.K. Damage, loose Refasten motor, contact
motor manufacturer, new
motor; take out of service
Software
Check version In latest
version
Not latest version Import update
Components Frequency Description Criteria Measures if rejected