MY20B01-22_1.0_21.06.2019
37
Overview
3.6.4.10 System settings and data
In order to see the system settings and data, the
rider has to call up the system settings. The rider
can change the values of the system settings, but
not the system data.
3.6.4.11 Additional eShift system setting
Applies only to pedelecs with eShift with
Shimano DI2 automatic hub gears, with manual
Shimano DI2 hub gears and with Rohloff E-14
Speedhub 500/14
The following additional functions are available on
the function display:
Applies only to pedelecs with eShift with
Shimano DI2 derailleur gears
The following additional functions are available on
the function display:
Applies only to Pedelecs with eShift with NuVinci
H|Sync/ enviolo with Optimized H|Sync
The following additional functions are available on
the function display:
3.6.5 System message
The drive system monitors itself continuously and
if an error is detected, it is indicated by a system
message. The system may switch off
automatically depending on the type of error. You
will find assistance for system messages in 8.5
First aid. There is a table of system messages in
the Appendix.
3.6.6 ABS indicator lamp
The anti-blocking system indicator lamp must light
up after the system has started up and must go
out once speed has reached about 5 km/h. If the
ABS indicator lamp does not light up when the
electric drive system starts, the ABS is defective.
An error code on the display also tells the rider
that it is defective.
Figure 24: ABS error message on the KIOX display
If the indicator lamp does not go out after you set
off or it lights up while you are riding, this means
there is an error in the anti-blocking system. The
anti-blocking system is then no longer active. The
brake system itself remains functional. It is only
the anti-blocking system control which no longer
operates.
Screen display Function
- C L O CK + Changing the time
- W H E E L CIRC U M + Value of the wheel circumference in
mm
- E NGLISH + Changes the language
- U N IT KM/M I + Selects whether the speed and
distance are displayed in kilometres
or miles
- T I ME FORM A T + Select whether the time is displayed
in 12-hour clock or 24-hour clock
format
- SHIFT RECOM.
OFF +
Switches the gear recommendation
on and off
Table 37: Changeable system settings
Screen display Function
POWE R O N HOU R S Display of the total journey duration
DISPL. VX.X.X.X Display software version
DU VX.X.X.X Drive system software version
DU# XXXX XXXXX Drive system serial number
SER V I C E MM/YY YY (Alternative) defined inspection
date
SER V . XX KM/M I (Alternative) defined inspection
BAT. V X . X. X.X Software version
1.B A T V X .X .X.X Software version
2.B A T V X .X .X.X Software version
Table 38: System data, not changeable
Screen display Change
SE T S T ART GEAR You can change the gear in this
menu option.
Table 39: Set start gear
Screen display Change
ADJ U S T GEAR This is where you can make a fine
adjustment to the Shimano DI2.
You'll find the specified setting
range in the gear manufacturer’s
operating instructions. Make the
fine adjustment as soon as you
hear any unusual noises from the
gear shift.
Table 40: Additional journey information
Screen display Change
CAL I B R A T ION This is where you can perform
a calibration on the stepless
gear. Follow the instructions on
the display.
Table 41: Changing the system settings
To Next Page
Loading...
