EasyManua.ls Logo

Bosch CHP CE 400 NE - 3-Draught Waste Heat Boiler for Use of Waste Heat Only; System Extension with Peak Load Boiler

Bosch CHP CE 400 NE
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System components
15
Systemlösung – 6 720 885 509 (2018/03)
2.5.2 3-draught waste heat boiler for use of waste heat only
If, due to very high waste heat mass flow or very high flue
gas temperatures, the limits of use of the waste heat
boiler HRSB should not be sufficient, a
3-draught waste heat boiler can be used for waste heat
utilisation only.
Fig. 8 Bosch 3-draught waste heat boiler
2.5.3 System extension with peak load boiler
If the motor waste heat provided by the CHP module is
not sufficient for the heating water supply or if it shall be
supply also redundantly to the CHP module, the system
can be extended by a boiler for covering these loads.
Fig. 9 Function diagram: System extension via peak load boiler (strongly simplified depiction)
[1] 4-draught steam boiler
[2] Economiser
[3] Chimney
[4] Flue gas heat exchanger
[5] Water service module
[6] Mains power supply
[7] Consumer
[8] Boiler
[9] Manifold
[10] Memory
[11] CHP
[12] Flue gas bypass
Current
Water/condensate
Steam
Flue gas
6 720 819 535-13.1T
6 720 819 535-14.1T
1
2
3
3
5
6
7
8
10
9
11
12
4

Related product manuals