Need help?Do you have a question about the Bosch Compress 7000i AW and is the answer not in the manual?
General| Type | Air-to-water heat pump |
|---|---|
| Refrigerant | R410A |
| Energy Efficiency Class (Heating) | A+++ |
| Energy Efficiency Class (Cooling) | A++ |
| Operating Temperature Range (Heating) | -20°C to +35°C |
| Operating Temperature Range (Cooling) | +46 °C |
| Sound Power Level (Outdoor Unit) | 52 dB |
| Dimensions (Indoor Unit) | Not available |
| Weight (Indoor Unit) | Not available |
Defines signal words and symbols used in warnings and instructions for safe operation.
Outlines essential safety practices for plumbers, installers, and electricians during installation.
Specifies that only authorized personnel should perform installation, operation, and maintenance.
Details safety precautions for electrical connections, requiring authorized installers and isolation.
Instructs on how to inform the user about operation, safety, and required maintenance.
Lists limit values for heating system water quality to prevent corrosion and ensure performance.
Illustrates the main components included with the heat pump unit.
Details possible combinations of the heat pump with various indoor units.
States compliance with EU legislation and provides internet address for the full declaration.
Locates and describes the information found on the heat pump's data plate.
Provides a visual overview of the heat pump's main components and connections.
Presents diagrams with detailed measurements for different heat pump models.
Illustrates required minimum clearances around the heat pump for ventilation and access.
Advises on selecting stable outdoor locations, considering access and noise propagation.
Explains how to route condensate drain pipes and recommended disposal methods.
Specifies requirements for heating system water volume to ensure efficient heat pump operation.
Details instructions for transporting and storing the heat pump unit correctly.
Guides on removing packaging and checking contents of the heat pump delivery.
Provides a general step-by-step checklist for the installation process.
Explains how to correctly mount and level the heat pump on a stable surface.
Introduces the connection section, covering pipework and electrical aspects.
Provides general guidelines and notices for making pipework connections, including cleaning and insulation.
Discusses condensate drainage, frost protection, and routing of drain pipes.
Details how to connect the heat transfer medium pipes between the heat pump and indoor unit.
Covers electrical connections, safety, wiring, and CAN-BUS communication setup.
Illustrates the process of attaching the heat pump's side panels and cover.
Warns about electrical hazards, capacitor discharge, and isolation procedures.
Alerts to the danger of refrigerant leaks and necessary immediate actions.
Advises on protecting sensitive electronic expansion valves from impact damage.
Warns about insulation deformation at high temperatures and precautions during soldering.
Shows the installation process for an optional heating cable accessory.
Discusses the company's commitment to environmentally compatible and recyclable packaging.
Explains the dismantling and recycling process for used appliance assemblies.
Provides guidance on proper disposal of electronic equipment according to regulations.
Presents detailed technical specifications for alternating current heat pump models.
Lists detailed technical specifications for three-phase current heat pump models.
Describes the operational temperature limits of the heat pump without auxiliary heating.
Shows a schematic diagram of the heat pump's refrigerant circuit components.
Illustrates the wiring diagram for power supply via transformer for AC and 3-phase units.
Details the wiring connections for the I/O module card and its components.
Provides tables correlating temperature sensor readings with resistance values.
Directs users to information regarding fluorinated greenhouse gases used as refrigerant.
To Next Page