Need help?Do you have a question about the Bosch Compress 3000 AWES 2-6 and is the answer not in the manual?
Describes warning signals and symbols used in the document.
Instructions for target group, intended use, installation, commissioning, service, electrical work, and handover.
Describes directives and regulations related to water quality for heating systems.
Lists the components included in the package with the indoor unit.
Describes AWES indoor units and their possible combinations with outdoor units.
Mentions compliance with European Directives and national requirements.
Shows a diagram illustrating the components and pipework connections of the indoor unit.
Guidance on mounting the indoor unit on a suitable wall.
Essential pre-installation checks to ensure proper setup.
Explains how the heat pump system operates based on demand.
Specifies the product's purpose and limitations for safe operation.
Requirements for thermal insulation of heat-conducting pipework.
Guidelines for handling and storing the indoor unit to prevent damage.
Instructions for physically connecting the indoor unit.
A comprehensive step-by-step checklist for the recommended installation process.
Specific connection steps for the indoor unit with an integrated electric booster heater.
Procedure for filling the system with water and purging air.
Details on the integrated PCO heating pump and its control.
Information regarding the selection and connection of the PC1 heating circuit pump.
Instructions for connecting the indoor unit to the EMS bus.
Instructions for connecting the indoor unit to the CAN bus.
ESD precautions for handling printed circuit boards to prevent damage.
General information on fitting temperature sensors for system control.
Specifics for installing and connecting the flow temperature sensor TO.
Specifics for installing and connecting the outdoor temperature sensor T1.
Information on connecting external inputs for remote control functions.
Detailed connection diagram for the SEC 20 installer module.
Details on different connection methods for the EMS bus.
Procedure for venting air from the indoor unit.
Steps for setting the correct operating pressure in the heating system.
Monitoring pressure and overheating protection for safety.
Steps for performing a function test on the system components.
Checking and monitoring system operating temperatures.
Instructions for cleaning the particle filter to ensure proper flow.
Instructions for installing a temperature controller as an accessory.
Guidance on installing a domestic hot water cylinder.
Connecting the DHW cylinder temperature sensor TW1.
Instructions for connecting the diverter valve VW1.
Installing heating circuit modules for multiple heating circuits.
Installation and settings for the DHW circulation pump PW2.
Considerations for installing the unit for cooling mode operation.
Installing condensation point sensors for cooling mode.
Guidance for installing the system for swimming pool heating.
Notes on cooling mode when using fan convectors.
Installation and commissioning of the IP module for remote control.
Using the unit independently without the outdoor component.
Product disposal and environmental aspects.
Packaging materials and procedures for used appliance disposal.
Technical specifications for the indoor unit with electric booster heater.
Overview of various system configurations for the heat pump.
Details a specific system configuration involving heat pump and immersion heater.
Glossary explaining various hydraulic symbols used in the manual.
General overview of the electrical connections for the unit.
Diagrams and instructions for CAN and EMS BUS connections.
Details on terminal connections for different power supply configurations.
Wiring diagram for a 400V 3N indoor unit with a 230V 1N outdoor unit.
Wiring diagram for a 400V 3N indoor unit with a 400V 3N outdoor unit.
Specific wiring diagram for the indoor unit with an integrated electric booster heater.
Information on connecting a PV system to the heat pump.
Cable planning and specifications for various connections.
Tables showing resistance values for temperature sensors at different temperatures.
A report template for documenting the system commissioning process.
To Next Page
General