EasyManua.ls Logo

Bosch CTL636E SERIES - Touch display operation; Initial use; General setup and first use; Setting up the appliance

Bosch CTL636E SERIES
132 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
Robert Bosch Hausgeräte GmbH
en
Touch display (left and right)
Depending on the setting, different elds
are shon in both the touch displays. A eld
is activated when touched either to enter
settings or change values�
Initial use
General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines)� Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit�
A
Before the appliance can be
switched on and used, it must
be assembled and connected
according to the enclosed assembly
instructions
Setting up the appliance
Remove any protective plastic lm.
F
Important: Only use the appliance
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use�
Take hold of the appliance door by the
recessed grip and open�
Remove the water tank, rinse it and ll it
with fresh water up to the “max�” mark�
Replace the water tank and click into
place�
Remove the bean container, ll with
coffee beans and replace�
Set the mains switch to I and close
the appliance door
The appliance heats up and is rinsed�
The control panel is activated�
Language” appears�
Turn the control ring with your nger to
select the desired language and touch the
[ Water hardness ] eld.
F
It is important to set the water hard-
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run�
The preset water hardness is level 4�
If a water softener is installed in the
house, please set the water hard-
ness to level 3� You can also check
the water hardness by asking your
local water supplier
Use the enclosed test strip to determine
the water hardness. Briey dip the test
strip in water and check the result after
one minute�
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
Turn the control ring with you nger to set
the water hardness determined�
Touch [ Set-up complete ]� The settings
are saved�
The appliance is ready to use as soon
as the drink symbols are shown and the
m lights up�
The integrated fan switches on each time
a drink is dispensed and switches off again
after a few minutes�
When the appliance is used for the rst time
after running a service program, or if it has
not been operated for a long period, the rst
beverage will not have the full aroma and
should not be consumed�

Table of Contents

Related product manuals