59
CTL636E.. | 07/2014
en
Problem Cause Solution
Display shows
“Refill with still water
or remove filter”
Water tank wrongly inserted Insert water tank correctly
Carbonated water in the water
tank�
Fill the water tank with fresh
tap water�
Float is stuck in the water
tank�
Remove the tank and clean
thoroughly�
New water lter not rinsed
according to instructions, or
water lter used or defective.
Rinse the water lter
according to the instructions
and then switch on, or use
a new water lter.
Air in the water lter. Dip the water lter into water
until no more air bubbles
escape, replace the lter.
Display shows
“Empty drip trays”
despite them being empty�
Drip tray is soiled and wet� Clean and dry the drip tray
thoroughly�
Display screen reads
“Insertdrip trays” even
though drip tray in use�
Inside of appliance
(tray holder) dirty�
Clean the inside�
Water dripped onto the inner
oor of the appliance when
the drip tray was removed�
Drip tray was removed too
soon�
Wait a few seconds after
the last drink was dispensed
before removing the drip tray�
Display shows
“EXXX
please press on/off”
Appliance is too warm� Leave the appliance to
cool down�
Dirty brewing unit� Clean the brewing unit�
If you are unable to solve the problem, always call the hotline!
You will nd the telephone numbers at the back of these instructions.
Technical specications
Power connection (voltage – frequency) 220-240 V – 50/60 Hz
Heater wattage 1600 W
Maximum static pump pressure 19 bar
Maximum water tank capacity (without lter) 2�4 l
Maximum capacity of the coffee bean container 500 g
Length of power cable 1�7 m
Dimensions (H x B x D) 455 x 495 x 375 mm
Weight, empty 19-20 kg
Type of grinding unit Ceramic
To Next Page
Loading...
