6 720 820 871 (2016/12)CR 400 | CW 400 | CW 800
Working with the main menu | 21
5.3.1 Observe with constant heating circuit
(e.g. swimming pool or ventilation unit)
If the control type Constant is set for a heating circuit, the
operation deviates from the description in the in the following
respects:
• In the Heating > Operating Mode menu, the automatic
mode is activated for the constant heating circuit (Auto) or
the control is permanently switched on or off to a constant
temperature (On/Off).
• The constant heating circuit is heated in the automatic
mode by taking account of the time program.
• In the time program, the On and Off operating modes are
available.
• The constant heating circuit is not displayed in the
standard display.
• The temperature for the constant heating circuit can be set
in the service menu only by a contractor.
5.3.2 Adapting Time program for automatic mode
To set the same switching times for multiple days of the week:
▶ Set switching times for a group of days, e.g. Mon-Sun or
Mon-Fri.
▶ Adjust the time program for the specific days of the week
for which different settings are required under Monday ...
Sunday (detailed description Æ Tab. 18, page 23).
Menu: Time program
The time program ensures automatic changeover between
temperatures or operating modes at defined switching times.
The user interface has two time programs for each heating
circuit. Up to a maximum of six switching times per day can be
programmed, each with a temperature or operating mode. The
default settings for the time programs provide economic
heating overnight.
If the settings, temperatures or switching times of the time
program do not meet your needs, you can adapt the time
program. If you do not require heating overnight, speak to your
contractor. He has access to additional settings for configuring
setback mode.
The following table shows you how to activate and select time
programs for the heating system.
If an CR100 has been assigned to a heating circuit as a remote
control, you can also activate the operating modes from the
corresponding remote control (Æ CR100 operating
instructions). In this case no freely adjustable temperatures
can be assigned to the time slots.
The time program can only be set using an app
on a smartphone or a similar terminal
appliance if the Type of time program >
Levels setting is selected.
Menu item Description
Type of time
program
There are two ways to set a heating
program. Freely adjustable temperatures
can be assigned to the individual
switching times or the time program
switches between two Levels, assigned
to the Heating and the Setback
operating modes.
Activate time
program
Activating automatic mode triggers
control of the room temperature
according to the settings in the selected
time program (My time program 1 or My
time program 2).
Table 16 Time program settings for heating
My time
program 1
6 switching times can be set for each day
or group of days. One of the two
operating modes can be assigned to each
switching time in automatic mode. The
minimum duration of a time slot between
two switching times is 15 minutes.
Reset prog. Here My time program 1 can be reset to
the default setting.
My time
program 2
Æ My time program 1
Reset prog. Here My time program 2 can be reset to
the default setting.
Menu item Description
Table 16 Time program settings for heating
To Next Page
Loading...
