Bosch CW 800 - Adjust the type of time program; Activate time program for the heating system

6 720 820 871 (2016/12) CR 400 | CW 400 | CW 800
22 | Working with the main menu
Operation Outcome
Adjust the type of time program
▶ Press the menu key to open the main menu.
▶ Turn the selector to highlight Heating.
▶ Press the selector to open the Heating menu.
▶ Turn the selector to highlight the Time program menu.
▶ Press the selector to open the Time program menu.
▶ If two or more heating circuits are installed, turn the selector to highlight Heating
circuit 1, 2, ..., 8 and press the selector.
▶ Press the selector.
▶ Turn the selector to highlight the desired setting for Type of time program.
▶ Press the selector to activate the selected setting.
Activate time program for the heating system (automatic mode)
If two or more heating circuits are installed, the heating circuit must be selected before
automatic mode is activated (Æ Chapter 4.1, page 9).
▶ If the standard display is active during manual operation, press the auto key to
activate the automatic mode.
If a time program of the 2 temperature levels type is active, temperatures for the
heating system are shown in a pop-up window in the lower part of the display. The
currently valid temperature flashes.
If a time program of the Freely adjustable temperature type is active, automatic
mode is shown in a pop-up window in the lower part of the display.
Select active time program for the heating system
▶ If the standard display is active, press the menu key to open the main menu.
▶ Turn the selector to highlight Heating.
▶ Press the selector to open the Heating menu.
▶ Turn the selector to highlight Time program.
▶ Press the selector to open the Time program menu.
▶ Turn the selector to highlight Activate time program.
Depending on the installed system, it may be necessary to select a heating circuit.
▶ Press the selector.
▶ Turn the selector to highlight My time program 1 or 2 and press the selector.
The user interface operates in automatic mode with the selected time program (if two
or more heating circuits are installed, it only operates in the selected heating circuit).
Table 17 Activating and selecting time programs for the heating system
6 720 815 237-23.1O
6 720 815 237-24.1O
6 720 815 237-25.1O
6 720 815 237-26.1O