Bosch CW 800 - Changing the room temperature

6 720 820 871 (2016/12) CR 400 | CW 400 | CW 800
10 | Getting started
4.3 Changing the room temperature
If the control type constant is set for a heating
circuit (e.g. swimming pool or ventilation unit),
the temperature for this heating circuit can be
set only by a contractor. In this case, auto and
man keys do not have any function.
Operation Outcome
To check the current required room temperature
Automatic mode
▶ Press the auto key.
The room temperature required currently (active operating mode) and the next
switching time are shown in a pop-up window in the lower part of the display.
Manual operation
▶ Press the man key.
The required room temperature is shown in a pop-up window in the lower part of
the display.
If manual operation with restricted duration is active, the required room
temperature and the duration of manual operation are displayed.
If it is too cold or too warm for you today: Change the room temperature temporarily
Automatic mode
Changing the room temperature until the next switching time
▶ Turn the selector to set the required room temperature.
The corresponding time slot is displayed in bold in the time program bar chart.
▶ Wait a few seconds or press the selector.
The user interface operates with the modified setting. The change applies until
the next switching time in your heating system time program is reached. After
this, the time program settings are restored.
Undoing a temperature change
▶ Turn the selector until the corresponding time slot is no longer displayed in bold
in the time program bar chart and press the selector
-or-
▶ To activate manual operation and then automatic mode:
– Press the man key.
– Wait a few seconds or press the selector to close the pop-up window.
– Press the auto key.
The change is undone.
Table 7 Getting started – Room temperature
6 720 815 237-04.1O
6 720 815 237-05.1O
6 720 815 237-06.1O