6 720 820 871 (2016/12) CR 400 | CW 400 | CW 800
28 | Working with the main menu
The following table shows you how to adapt the settings for DHW heating.
Operation Outcome
Open the menu for the DHW settings
▶ If the standard display is active, press the menu key to open the main menu.
▶ Turn the selector to highlight DHW.
▶ Press the selector to open the DHW menu.
Selecting and setting the time program for DHW heating
▶ Open the menu for the DHW settings.
▶ Turn the selector to highlight Time program.
▶ Press the selector to open the Time program menu.
▶ Press the selector to open the Operating Mode menu.
▶ Turn the selector to select As heating circuit time program and press the selector.
The time program for the heating system now also determines the switching times of
the time program for DHW heating (Æ Chapter 5.4.3, page 27). Depending on the
installed system, it may be necessary to select a DHW system.
▶ Turn the selector to mark the Own time program menu item and press the selector.
The time program for hot water is independent of the time program for the heating
system. The switching times can be set separately in the Time program > My DHW
time program menu (operation as described in Chapter 5.3.2 starting on page 21).
The DHW temperatures set for the operating modes are valid in the time slots.
Activate constant DHW heating
▶ Open the menu for the DHW settings.
▶ Turn the selector to highlight the Time program menu item.
▶ Press the selector to open the Time program menu.
▶ Press the selector to open the Operating Mode menu.
▶ Turn the selector to highlight Always on - DHW red. or Always on - DHW.
▶ Press the selector.
DHW heating is active without interruption. Depending on the installed system, it may
be necessary to select a DHW system.
Table 24 Adapting the settings for DHW heating
6 720 815 237-39.1O
6 720 815 237-40.1O
6 720 815 237-41.1O
6 720 815 237-42.1O
To Next Page
Loading...
