Bosch CW 800 - Menu structure of the info menu; Information about the heating

6 720 820 871 (2016/12)CR 400 | CW 400 | CW 800
Calling up information about the system | 37
Fig. 5 Menu structure of the info menu
1) Only available if a MB LAN2 communication module or an
appliance electronics with integrated communication
interface (MX 25) is installed.
2) Only available without cascade module (e.g. MC400) for
certain types of heat source.
Menu: Heating
The menu items in this menu are only available for installed
heating circuits.
Info Internet
1)
Heating IP connection
Heating circuit 1 ... 8 Server connection
Set room temp. SW version
Actual room temp. Login data
Actual flow temp. MAC address
Operating Mode System information
2)
DHW Burner starts
DHW system I ... II Burner runtime
Set temp. Water pressure
Actual temp. Operating code
Therm. disinf. DHW cyl. Energy consumption
2)
Solar 24h: gas heating
Solar sensors 24h: elec. heating
Solar yield 24h: gas DHW
Outdoor temp. 24h: elec. DHW
Outdoor temp. curve 30d: gas heating
Outdoor temp. 30d: elec. heating
30d: gas DHW
30d: elec. DHW
6 720 815 820-61.1O
Menu item Description
Set room
temp.
The desired room temperature that is
currently valid in the selected heating circuit:
• In automatic mode, the desired room
temperature can change several times a
day, if necessary.
• In manual operation, it is always constant
Actual room
temp.
Currently measured room temperature in the
selected heating circuit
Actual flow
temp.
Currently measured flow temperature in the
selected heating circuit
Operating
Mode
Currently valid operating mode in the
selected heating circuit (Off, Heating,
Setback, Summer, Holiday or Manual)
Table 31 Information about the heating