Bosch D1260 - Unbypass a Point? (Command + 0 + 0); Description; Using Unbypass a Point

Security System | User's Guide | Part II: System Commands - UNBYPASS A POINT? (COMMAND + 0 + 0)
Bosch Security Systems | 9/04 | 4998122475D 60
UNBYPASS A POINT? (COMMAND + 0 + 0)
Description
Unbypassing a point is a way to return a bypassed point to the
security system so that it can once again respond to trouble
and alarm conditions.
Using Unbypass a Point
1. Ensure your keypad shows idle
disarmed text.
2. Press the
COMMAND key.
3. The display shows *System
Command*.
4. Press the
0 + 0 keys.
+
If you prefer, you may use the Command Menu in
place of steps 2 and 3 to initiate this function.
Press the Menu> key to enter the Command
Menu, then press Next> repeatedly until you
reach the UNBYPAS A POINT ?> prompt. Press
the UNBYPAS A POINT ?> soft key.
5. The display shows:
If you know the point number
you wish to unbypass, enter the
number and press the Enter>
soft key or the
ENTER key.