Bosch D7412GV3 - Install the GV3 Control Panel in the Enclosure; Replace the Terminal Strips

8 en | Upgrade GV3 Hardware and Programming D9412GV3/D7412GV3/D7212GV3
F01U170805 | 01 | 2010.11 Quick Reference Guide Bosch Security Systems, Inc.
2.2.3 Install the GV3 Control Panel In the Enclosure
1. Place the GV3 Control Panel in the enclosure using the mounting skirt hook holes on the
back of the control panel and the mounting skirt hooks on the enclosure.
2. Replace the lock down tab screw.
2.2.4 Replace the Terminal Strips
1. Replace the four removable terminal strips by pushing them straight down until they snap
into position.
2. Connect the battery and AC power.
1 - Mounting skirt hook holes
2 - Mounting skirt hooks
3 - Lock down tab
NOTICE!
If the control panel was previously mounted using the screw hole configuration, the you must
re-mount the new control panel. The GV3 control panel mounting screw hole locations do not
align with the locations for older control panels.