Bosch Security Systems
Divar | Installation Manual | Operating instructions EN | 3-11
• Fill in a time and date from which to start the search.
• Fill in an end time and date to limit the time span of the search.
• If ATM/POS is selected, fill in the text string (16 characters maximum)
you wish to search for. This text string is case insensitive.
•Select Start Search (or press F2) to initiate the search procedure.
•If Smart Motion Search is selected, you must set the motion sensitivity
and select an area before the search procedure is initiated.
• Use the arrow keys to adjust the Motion Sensitivity. The higher the
value, the higher the sensitivity.
•Select Motion Area to define the picture area that is to be examined for
motion.
• Use the arrow keys to move around the grid. Press F1 to insert a motion
detection area. Use the arrow keys to enlarge it.
• Press F1 again to save the area. Press the escape key to cancel and return
to grid square selection.
• Press the select key to leave the grid. F2 clears all motion detection areas.
•Select Start Search (or press F2) to initiate the search procedure.
• Press the escape key to exit the search mode and return to the
previous mode.
>> SEARCH RESULTS
• The recording fitting the filter and closest to the selected date and time is
shown first.
• Use the up/down arrow keys to move through a long list. The selected
recording is shown.
• Press the select key for a full-screen playback of the selected
recording.
• Press the search key during playback to return to the list.
• Press the escape key to return to the filter menu.
PLAYBACK SEARCH
SEARCH RESULTS
CAMERA 1 MOTION 2002-03-14 15:00:17
To Next Page
Loading...
Need help?
General