DS7200V2-UK Installer's Guide Copyright 2007 Bosch Security Systems, Inc. P/N: 4998152533-02 Page 113
PART IV: CONTROL PANEL PROGRAMMING
Format for Destination 1 (2)
• Address:
−
Format for Destination 1: 0064
− Format for Destination 2: 0130
• Default: 2 (Contact ID)
• Selections:
−
2 = Contact ID
− 3 = SIA 300
− 4 = Basic Pager
− 6 = BSIA Fast Format
− 7 = Personal Dialing Format
− 11 = SIA 300 with Text Blocks
If you enable network communication, the control panel automatically selects Contact ID as the reporting format. Contact ID
only supports four-digit account numbers. As a result, the control panel automatically truncates account numbers to four digits.
Alternate Communication Options
• Address Range:
− IP Address 1, Destination 1: 3506
− IP Address 2, Destination 1: 3514
− IP Address 1, Destination 2: 3522
− IP Address 2, Destination 2: 3530
• Default: 0
• Selections: 0, 1, 3, 5, 7
Enter This Data Digit to Select Options
Alternate Communication Options 0 1 2 3 4 5 6 7 8 9 10
11
12
13
14
15
No Alternate Communication
•
Enable Alternate Communication
•
•
•
•
Enable Anti-Replay
•
•
Use ARC Acks
•
•
Reserved
• Enable Alternate Communication: Select this option to enable network communication. You must enter at least one IP
address as a routing destination. See
IP Address 1 (2) for Destination 1 (2) on page 112 for more information.
• Enable Anti-Replay: Anti-replay prevents unauthorized messages from being sent to the ARC and being recognized as
having originated from the control panel. Enable this option to use the anti-replay procedure. To use this option, make sure
“Include IP Address” is enabled in
Network Interface Module Options on page 115.
• Use ARC Acks: If this option is enabled, the control panel waits for an acknowledgment (Ack) from the ARC before sending
a second message. If this option is disabled, the control panel waits approximately 120 seconds between sending messages
(disable only for special applications).
Remote Programming Callback Number Alternate Communication Options
• Address: 3538
• Default: 0
• Selections:
− 0 = No Alternate Communication
− 1 = Enabled Alternate Communication
If an IP address is entered into the Remote Programming Callback Number addresses (Addresses 0181-0212), RPS can be
used to program the control panel over an Ethernet network.
Select “1” if an IP address is entered in the Remote Programming Callback Number addresses.
To Next Page
Loading...
