DS7200V2-UK Installer's Guide Copyright 2007 Bosch Security Systems, Inc. P/N: 4998152533-02 Page 83
PART IV: CONTROL PANEL PROGRAMMING
Sensor Monitor Time
• Address: 1032-1033
• Default: 0,7
• Selections: 0-9
This parameter determines the number of days (00 to 99) that the control panel can function without sensor (zone) activity
(time accumulates only when the area is off/disarmed).
Assign this parameter by zone function (see “Options 1, Zone Function ##” in the
DS7200V2 Expert Programming Guide
(P/N: 4998153891)). This parameter does not apply to fire zone types or non-fire 24-hour zone types.
If there is no sensor activity after the entered time period, a trouble report is sent.
Alarm Event Abort Window
• Address: 1034
• Default: 3 (45 seconds)
• Selections:
−
0-1 = 15 seconds
− 2 = 30 seconds
− 3-15 = 45 seconds
This parameter sets the length of time that a user has to enter a valid PIN and cancel an alarm before an alarm report is sent.
If a user acknowledges a non-fire alarm event by entering their PIN before the Alarm Event Abort Window expires, the
following events occur:
1. The alarm event is aborted. Alarm, Cancel and Restoral reports associated with the alarm are not transmitted. The alarm
event becomes a local only event.
2. The user hears a unique three long beep tone at the keypad.
3. The text keypad indicates the aborted alarm on the display. The LED keypad indicates the aborted alarm with a slow flash
in Alarm Memory.
See the
DS7200V2 Expert Programming Guide (P/N: 4998153891) for more information on the Cancel Event enabled option
and the Enable Alarm Event Abort option.
This parameter only affects non-fire zones. Fire and Fire with Verification zones are not affected by
enabling this parameter.
Zone Trouble, Restoral from Trouble Report Routing
• Address: 1038
• Default: 1 (Reports to Destination 1, Events to Log/Printer)
• Selections:
− 0 = No Reports, no Events to Log/Printer
− 1 = Reports to Destination 1, Events to Log/Printer
− 2 = Reports to Destination 2, Events to Log/Printer
− 3 = Reports to Destinations 1 & 2, Events to Log/Printer
− 4 = Reports to Destination 2 only on Destination 1 Comm Fail Event, Events to Log/Printer
− 5 = No Reports, Events to Log/Printer
Zone Trouble report events include the following:
• RF Low Battery {121}
• RF Tamper Trouble {121}
• Trouble Events {139 – 145}
Restoral from Trouble report events include Restoral from Trouble {146-152}.
To enable reporting at the Global Reporting Options prompt (see page 47), at least one phone number
(or IP address) must be entered for one routing destination (see page 42).
To Next Page
Loading...
