Bosch Evolution 300 Series - Pressure Regulator

2:17
Pressure Regulator
A single pressure regulator is used to control gas pressure to the bake,
broil and surface burners. The regulator is mounted  the left rear
corner of the range as seen in photo D. The incoming gas supply line is
connected to the regulator opening indicated by the arrow in the photo.
Incoming
Gas Supply
Photo D
The pressure regulator has a shutoff lever that is used to turn off the
gas supply to the oven burners only hoto E
When this lever is in the off position no gas is supplied to the bake or
broil burner gas safety valves and these burners cannot light. If the
oven burners will not light but the igniters appear to be working, check to
see if this lever has been turned to the  position.
When converting the range for use with LP gas or making other
adjustments the pressure regulator can be accessed from the front
of the range. Remove the storage drawer and the regulator can be
accessed from the underside of the range as seen in photo F.
Photo F
Regulator
t
t
t
t
t
t
oo
o
o
o
o
Ph
Ph
P
P
ot
t
o
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E
E